Soon after realizing the possible of the h2o heater closet in her residence, Courtney Weston, of Often Rooney, made the decision to change it into a practical area. Read through on to see how Courtney turned it into an open up shelved pantry!
Drinking water Heater Closet Turned Into Open up Shelved Pantry
In an 1100 sq. ft. residence, my partner and I are constantly hunting to optimize the use of area we have. We a short while ago relocated our incredibly hot h2o heater to the exterior of our residence to absolutely free up area in our modest kitchen area. By eliminating a door that constantly hit the refrigerator, cleaning up the closet, introducing tile and a beadboard end to the partitions we had been left with a thoroughly clean palette to get the job done with.
I designed a record of requires for the pantry and drew many mock-ups of what the pantry could ultimately develop into. The leading precedence was foods organization and a modest area for cleaning supplies. At the close of the working day, we made the decision basic was best due to the fact the pantry will now be left open up.
Here’s how we built the open up shelved pantry.
- two sheets of 32 sq. ft. beadboard
- (3) one in. x two in. furring boards
- one sheet of ¾ in. x 4 ft. x eight ft. birch plywood
- (two) Satin Nickel Coat and Hat Hook
You can lease these equipment from The Home Depot.
The Aged Drinking water Heater Closet
This is what we had been performing with after the h2o heater was relocated. Dingy partitions, unfinished floors and a fuel pipe to get the job done close to, but retain open up in scenario we need to have to accessibility it.
Installing the Beadboad and Shelf Braces
Very first, we took measurements of the 3 closet partitions and slash beadboard appropriately on a desk saw.
Subsequent, we found the studs and employed a nail gun to connect the boards.
Soon after the boards had been up, I slash one in. x two in. furring boards to the length of the shelves to be the braces.
Creating guaranteed every single brace was degree, I screwed them into the partitions. I spaced every single brace aside in accordance to what I preferred to in shape on the shelf.
Just before shifting on to putting in the shelves, I additional two hooks on the left wall for brooms and other kitchen area components to hold.
Installing the Open up Shelves
I slash the base shelf to span the width of the closet. It has a notch slash in for the fuel pipe to operate by means of.
Then, I slash a middle board to create a nook for brooms on the left side that calculated 52 in. significant.
I slash 3 shelves for foods organization that calculated 14 x twenty in.
Ultimately, I slash a board for the leading of the pantry that calculated 20½ x twenty in. with a notch slash out for the fuel pipe. I sanded and painted every single shelf prior to putting in them.
To put in every single shelf, I attached them to the braces with wooden glue and screws. I employed an L-bracket to connect the shelves to the middle board that established the nook.
Now, we have a thoroughly clean, open up pantry that gives us more room to retailer foods and kitchen area necessities!
The write-up Drinking water Heater Closet Turned Into Open up Shelved Pantry appeared first on The Home Depot Blog site.